The Bulk Validation Flow helps high-volume labs validate test results quickly by grouping them by test or device.
? How It Works
Go to Operations-> Parametre wise review
You will see devices and for which results are ready for validation
When you click on device you will see the list of parametres for device
For each parameter:
Results directly from the device are shown
Results can be reviewed, , or held
Once all parametres are reviewed then the test will be marked as completed, signed or dispatched based on setting
If a rerun is triggered:
It disappears from active list
Reappears with status “Rerun result” once new result is interfaced
? Setup Instructions
Ensure device interfacing is active
Only tests from interfaced devices will appear in this view.
Check the integration is correctly mapped and active.
Assign validation access
The user must have the appropriate role/permission to access the Operations → Bulk Validation screen.
Auto-actions configuration
For each test type, configure whether:
Reports are automatically signed
Reports are marked as completed post-validation
Reports are auto-dispatched after signing
Enable rerun/reflex logic (if applicable)
If rerun or reflex criteria are configured for a test, the system will:
Auto-trigger rerun if a result falls outside expected range
Auto-trigger reflex if a specific trigger parameter meets conditions
? Notes & Best Practices
Tests will only show if the parameter has been interfaced from the device
If all parameter are not interfaced, i.e some parametres are calculated then that needs to be approved from waiting list only to complete the flow
Suggested is to put calculation in the interfacing parser to send the calculated value via interfacing so can be reviewed from this flow
This view is designed for batch-based workflows, especially useful when a technician oversees a specific analyzer or department
.